Toyota Corolla (E120): Fuel
Preparation
Sst

Recomended tools

Ssm

Equipment

Other materials:
Inspection procedure
Hint:
start the inspection from step 1 in case of using the hand–held tester and start
from step 2 in case of not
using the hand–held tester.
1 Perform active test by hand–held tester(abs warning light)
Check that ”on” and ”off” of the abs warning light can be shown on the
...
Inspection
1. Cooler thermistor no.1
Check resistance between terminals 1 and 2 of cooler
thermistor no. 1 At each temperature, as shown in the
chart.
Resistance:
If resistance value is not as specified, replace the sensor.
2. Cooler and accessory assy
Inspect blower switch contin ...
Body panel undercoating areas
Apply pastar uwe or pastar uc to the chassis, floor underside, sheet metal
fitting weld points of the body, and
inside of the wheel house to prevent rust and noise, as well as protect the body
from flying rocks.
Hint:
work must be performed while wearing the appropriate protective ...


