Toyota Corolla Repair Manual: Diagnostics
Preparation
Sst
 |
09816–30010 | Oil pressure switch socket | Sfi system |
 |
09843–18040 | Diagnosis check wire no.2 | Sfi system supplemental restraint system |
Recomended tools
 |
09082–00040 | Toyota electrical tester | Sfi system supplemental restraint system electronic controlled automatic transaxle [ect] combination meter wireless door lock control system |
 |
(09083–00150) | Test lead set | Sfi system abs with ebd system supplemental restraint system electronic controlled automatic transaxle [ect] audio system cruise control system combination meter wireless door lock control system power door lock control system |
 |
(09083–00150) | Test lead set | Sfi system abs with ebd system supplemental restraint system electronic controlled automatic transaxle [ect] audio system cruise control system combination meter wireless door lock control system power door lock control system |
Engine control system
Preparation
Equipment
| Ohmmeter | |
| Radiator cup tester | |
| Torque wrench |
Preparation
...
Fuel
Preparation
Sst
Recomended tools
Ssm
Equipment
...
Other materials:
Circuit description
Refer to dtc p0010
Dtc no.
Dtc detection condition
Trouble area
P0011
Condition (a) or (b) continues after engine is warmed up and
engine speed at 550 to 4,000 rpm (problem of the advanced
ocv):
valve timing does not change from current valve tim ...
On–vehicle inspection
1. Inspect drive belt
Visually check the belt for excessive wear, frayed cords,
etc.
If any defect is found, replace the drive belt.
Hint:
cracks on the rib side of a belt are considered acceptable. If the
missing chunks from the ribs are found on the belt, it should be
replaced.
2 ...
Catalyst monitor (o2s type)
Preconditions
The monitor will not run unless:
mil is off.
Engine coolant temperature (ect) is 176°f (80 °C) or greater.
Intake air temperature (iat) is 14°f (–10 °C) or greater.*
Notice:
* 2002 and later my vehicles:
the readiness test can be completed in cold ambient conditi ...