Toyota Corolla (E120): Power steering

Preparation

Sst

Recomended tools

Recomended tools

Equipment

Equipment

Lubricant

Lubricant

Ssm

Ssm

Heater & air conditioner

    Share this page:

    Other materials:

    Precaution
    1. Check that the battery cables are connected to the correct terminals. 2. Disconnect the battery cables when the battery is given a quick charge. 3. Do not perform tests with a high voltage insulation resistance tester. 4. Never disconnect the battery while the engine is running. 5. Check that ...

    Inspection procedure
    1 Inspect dlc3 terminal voltage(ts terminal) Turn the ignition switch to on. measure voltage between terminals ts and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector between ...

    Inspection procedure
    1 Inspect shift solenoid valve(s1) Remove the shift solenoid valve s1. measure the resistance according to the value(s) in the table below. Standard: Connect the positive (+) battery lead to the solenoid connector terminal, and the negative (–) battery lead to the solenoid ...