Toyota Corolla (E120): Front suspension

Preparation

Sst

Recomended tools

Recomended tools

Equipment

Equipment

Rear suspension

    Share this page:

    Other materials:

    Inspection procedure
    1 Check relay (marking: starter cut) Inspect the relay continuity, as shown in the illustration and table. Standard: 2 Check tvip ecu Disconnect the tvip ecu connector.  turn the ignition switch position to the start.  measure the voltage between the termina ...

    For vehicles equipped with catalytic converter
    Caution: if large amount of unburned fuel flows into the converter, it may cause overheating and a fire hazard. To prevent this, observe the following precautions. Use only unleaded gasoline.  avoid prolonged idling. Avoid running the engine at idle speed for more than 20 minutes. ...

    Tire inflation pressure
    Checking the specified tire inflation pressure The recommended cold tire inflation pressure and tire size are displayed on the tire and loading information label. Inspection and adjustment procedure Tire valve Tire pressure gauge 1. Remove the tire valve cap. 2. Press the tip of the tire pres ...