Toyota Corolla (E120): Lubrication

Preparation

Sst

Equipment

Equipment

Lubricant

Lubricant

Ignition

    Share this page:

    Other materials:

    Circuit description
    Refer to dtc p0130 Dtc no. Dtc detection condition Trouble area P0133 After engine has been warmed up, if response time that heated oxygen sensor’s output voltage reaches from rich to lean. Or from lean to rich, is 0.6 Second or more during idling. ...

    Inspection procedure
    Hint Advanced timing over (valve timing is out of specified range) P0011 Retarded timing over (valve timing is out of specified range) P0012 If dtc p0011 or p0012 is displayed, check the vvt system circuit. Read freeze frame data using the hand–held tester o ...

    Ecm (1zz–fe)
    Replacement 1. Disconnect battery negative terminal 2. Remove glove compartment door assy 3. Remove ecm Remove the 2 clips using a clip remover. Then, open the cover. Disconnect the 4 ecm connectors.  remove the wire harness from the wire harness clamp. Remove the 2 ...