Toyota Corolla (E120): Engine hood/door

Share this page:

Other materials:

Inspection procedure
1 Check d squib circuit(airbag sensor assy center – horn button assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the horn button assy.  for the oran ...

Inspection procedure
1 Check courtesy lamp switch Check the courtesy switch, as shown in the illustration and table. Standard: 2 Check wire harness (integration relay  door courtesy sw) Disconnect the integration relay and door courtesy connectors.  check the continuity between th ...

Inspection procedure
1 Inspect dlc3 terminal voltage Turn the ignition switch to on.  measure voltage between terminals 13 (tc) and 4 (cg) of dlc3. Ok: voltage: 10 – 16 v 2 Check harness and connector(between cruise control ecu assy and dlc3) Check for open and short circuit in harness ...