Toyota Corolla (E120): Side mudguard sub–assy lh

Replacement

Hint

: use the same procedures for the rh side and lh side.

1. Remove side mudguard sub–assy lh

  1. Using a clip remover, remove the 8 retainers and 9 clips.
  2.  using a moulding remover, remove the mudguard.

2. Install side mudguard sub–assy lh

  1. Install the mudguard with 9 new clips.
  2.  install the 8 retainers to the mudguard.
    Share this page:

    Other materials:

    Inspection procedure
    1 Check wire harness(dlc3 – airbag sensor assy center) Turn the ignition switch to the lock position.  disconnect the aribag sensor assy center connector.  measure the resistance according to the value(s) in the table below. Standard: 2 Check wire harness(cg of dl ...

    Inspection procedure
    1 Check fuse(ecu–ig) Remove the ecu–ig fuse from the instrument panel j/b.  check the continuity of the ecu–ig fuse. Ok: continuity 2 Inspect terminal voltage(b) Remove the cruise control ecu assy with connector still connected.  turn the ignition switch ...

    Seat belts
    Make sure that all occupants are wearing their seat belts before driving the vehicle. WARNING Observe the following precautions to reduce the risk of injury in the event of sudden braking, sudden swerving or an accident. Failure to do so may cause death or serious injury. ■Wearing a seat belt E ...