Toyota Corolla (E120) 2002–2008 Repair Manual / Exterior/interior trim / Luggage compartment door garnish outside

Toyota Corolla (E120): Luggage compartment door garnish outside

Replacement

Hint

: the installation procedures are the removal procedures in reverse order. However, only installation procedures requiring additional information are included.

1. Remove luggage compartment lock cylinder & key set

  1.  remove the 2 nuts and luggage compartment lock cylinder.

2. Remove luggage compartment door garnish outside

  1. Remove the nut.
  2.  remove the 4 clips and garnish.

3. Install symbol emblem

  1.  using white gasoline, clean the garnish installation surface.
  2.  using a heat light, heat the garnish and emblem to 20 to 30 c (68 to 86 f).

    Notice

    : do not heat the garnish and emblem excessively.

  3.  install the emblem with the 4 clips.
    Share this page:

    Other materials:

    If a warning message is displayed
    The multi-information display shows warnings for system malfunctions and incorrectly performed operations, and messages that indicate a need for maintenance. When a message is displayed, perform the appropriate corrective action for the message. If a warning message is displayed again after the ap ...

    Replacement
    Hint: components: 1. Table of bolt, screw and nut Notice: be sure to tape the tip of the screwdriver when using it to disengage the meshing of the clips and claws. Hint: indicate the bolts, screws and nuts, which are necessary for installation and removal of the instrument panel, in th ...

    Inspection procedure
    1 Check p/t squib(rh) circuit(airbag sensor assy center – front seat outer belt assy rh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the seat belt pretensio ...