Toyota Corolla (E120): Clutch
- Clutch system (mtm)
- Clutch pedal sub–assy (mtm)
- Clutch master cylinder assy (mtm)
- Clutch release cylinder assy (mtm)
- Clutch unit (mtm)
- Clutch start switch assy (mtm)
Other materials:
Oxygen / af sensor heater monitor
Preconditions
The monitor will not run unless:
mil is off
drive pattern
connect the obd ii scan tool to the dlc3 to check monitor status
and preconditions.
Start the engine and allow it to idle for 9 minutes.
Drive the vehicle at 25 mph (40 km ...
Inspection procedure
1 Check d squib circuit(airbag sensor assy center – horn button
assy)
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connectors between the horn button assy
and the airbag sensor assy center.
for the blac ...
Door control transmitter
Registration
1. Registration of recognition code
Hint:
the add mode is used to retain the already registered codes while
registering a new recognition code.
This mode is used when adding a transmitter. If the number of the registered
codes exceeds 4, the
previously registered code wi ...