Toyota Corolla Repair Manual: Clutch start switch assy (mtm)

Overhaul

1. Remove manual transaxle assy 2. Remove clutch release fork sub–assy Remove the clutch release fork with clutch release bearing from the transaxle assy. 3. Remove clutch release beari ...

On–vehicle inspection

1. Check clutch start system Check that the engine does not start when the clutch pedal is released.  check that the engine starts when the clutch pedal is fully depressed. If ne ...

Other materials:

Check open circuit
For the open circuit in the wire harness in fig. 1, Perform a resistance check in step (b) or a voltage check in step (c) to locate the section. Check the resistance.  Disconnect connectors a and c and measure the resistance between them. Resistance: 1 Ω or les ...

Engine oil
With the engine at operating temperature and turned off, check the oil level on the dipstick. ■ Checking the engine oil 1 Park the vehicle on level ground. After warming up the engine and turning it off, wait more than 5 minutes for the oil to drain back into the bottom of the engine. 2 ...

Inspection procedure
1 Inspect shift solenoid valve(s2) Remove the shift solenoid valve s2.  measure the resistance according to the value(s) in the table below. Standard: Connect the positive (+) battery lead to the solenoid connector terminal, and the negative (–) battery lead to the sole ...