Toyota Corolla (E120) 2002–2008 Repair Manual / Clutch / Clutch start switch assy (mtm) / On–vehicle inspection
Toyota Corolla (E120): On–vehicle inspection
1. Check clutch start system

- Check that the engine does not start when the clutch pedal is released.
- check that the engine starts when the clutch pedal is fully depressed.
If necessary, replace the clutch start switch assy.
Other materials:
Inspection procedure
Hint:
start the inspection from step 1 in case of using the hand–held tester and start
from step 2 in case of not
using the hand–held tester.
1 Read value of hand–held tester(skid control sensor)
Check that there is no difference between the speed value output from
the speed sensor ...
Monitor description
While the engine is being cranked, the battery positive voltage is applied to
terminal sta of the ecm.
If the ecm detects the starter control signal (sta) while the vehicle is
driving, it will conclude that there is
a fault in the starter control circuit. The ecm will turn on the mil and a d ...
Inspection
1. Inspect inner rear view mirror assy
Inspect the electro chromic inner mirror operation.
Connect the positive (+) lead from the battery to terminal
1 and negative (–) lead to terminal 2.
) Attach black colored tape to the forward sensor to
prevent it from sensing.
&nb ...


