Toyota Corolla (E120): On–vehicle inspection

1. Check clutch start system

  1. Check that the engine does not start when the clutch pedal is released.
  2.  check that the engine starts when the clutch pedal is fully depressed.

If necessary, replace the clutch start switch assy.

    Share this page:

    Other materials:

    Receiving a phone call
    Answering the phone Press the off-hook switch. Refusing a call Press the on-hook switch. Receiving a call when on another call Press the off-hook switch. Pressing the off-hook switch again returns you to the previous call. Adjusting the ringtone volume when receiving a call Change the ringto ...

    Removal & installation and disassembly & reassembly
    1. Remove bench type rear seat cushion assy 2. Remove rear floor service hole cover Remove the rear service hole cover. Disconnect the fuel pump and vapor pressure sensor connector. 3. Work for preventing gasoline from spilling out Start the engine.  after the engi ...

    Monitor description
    While the engine is being cranked, the battery positive voltage is applied to terminal sta of the ecm. If the ecm detects the starter control signal (sta) while the vehicle is driving, it will conclude that there is a fault in the starter control circuit. The ecm will turn on the mil and a d ...