Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Combination meter / Seat belt warning lamp for driver’s seat does not
operate
Toyota Corolla (E120): Seat belt warning lamp for driver’s seat does not operate
Wiring diagram
Inspection procedure
1 Check combination meter assy
- Ground terminal c9–12 on the combination meter side.
- check that the warning lightlights up.
Ok: warning light lights up.
2 Inspect front seat inner belt assy lh
- Disconnect the front seat inner belt assy.
- check continuity front seat inner belt assy.
Repair or replace harness or connector
Other materials:
If a warning light turns on or a
warning buzzer sounds
Calmly perform the following actions if any of the warning
lights comes on or flashes. If a light comes on or flashes, but
then goes off, this does not necessarily indicate a malfunction
in the system. However, if this continues to occur, have the
vehicle inspected by your Toyota dealer.
Actions to ...
Disposal
Hint:
when scrapping vehicles epuipped with a seat belt pretensioner or disposing of a
front seat outer belt (with
seat belt pretensioner) always first active the seat belt pretensioner in
accordance with the procedure described
below. If any abnormality occurs in the seat belt pretensioner o ...
Check mode procedure
Hint:
hand–held tester only:
compared to the normal mode, the check mode has more sensing
ability to detect malfunctions. Furthermore, the same diagnostic
items which are detected in the normal mode can also be
detected in the check mode.
1. Check mode procedure(using the hand–held tester) ...