Toyota Corolla (E120): Heater & air conditioner

Share this page:

Other materials:

Transmission wire (atm)
Replacement 1. Remove transmission valve body assy 2. Remove transmission wire Disconnect the transmission wire connector.  removal the bolt and transmission wire. 3. Install transmission wire Coat a o–ring with atf.  install the transmission wire and bolt. To ...

Inspection procedure
1 Check side squib(lh) circuit(airbag sensor assy center – front seat airbag assy lh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the front seat airbag assy ...

Evap monitor (vacuum pressure monitor) (continued)
Preconditions The monitor will not run unless: mil is off. Fuel level is approximately 1/2 to 3/4. Altitude is 7800 feet (2400 m) or less.* Engine coolant temperature (ect) is between 40°f and 95°f (4.4 °C and 35 °C). Intake air temperature (iat) is between 40°f and 95 ...