Toyota Corolla (E120): Air conditioning system

Share this page:

Other materials:

Inspection procedure
1 Inspect dlc3 terminal voltage(tc terminal) Turn the ignition switch to on.  measure voltage between terminals tc and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector betw ...

Initialization
1. Reset memory Caution: perform the reset memory (at initialization) when replacing the automatic transaxle assy, engine assy or ecm. Notice: hand–held tester only Turn the ignition switch off.  connect the hand–held tester to the dlc3.  turn the ignition switch to th ...

Inspection procedure
1 Check relay (marking: starter cut) Inspect the relay continuity, as shown in the illustration and table. Standard: 2 Check tvip ecu Disconnect the tvip ecu connector.  turn the ignition switch position to the start.  measure the voltage between the termina ...