Toyota Corolla (E120) 2002–2008 Repair Manual / Automatic transmission / trans / Front differential oil seal (atm)

Toyota Corolla (E120): Front differential oil seal (atm)

Replacement

1. Remove front wheels

2. Remove engine under cover rh

3. Remove engine under cover lh

4. Drain automatic transaxle fluid

1.  remove the drain plug, gasket and drain atf.
2.  install a new gasket and drain plug.

   Torque: 17.5 Nvm (178 Kgf·cm, 13 ft·lbf)

5. Remove front drive shaft assy rh

6. Remove front drive shaft assy lh

7. Remove transaxle housing oil seal(rh)

1. Using sst, pull out the oil seal.

   Sst 09308–00010

8. Remove transaxle case oil seal(lh)

1. Using sst, pull out the oil seal.

   Sst 09308–00010

9. Install transaxle housing oil seal(rh)

1. Using sst and a hammer, drive in a new oil seal.

   Sst 09350–32014 (09351–32130, 09351–32150) oil seal drive in depth: 2.0 0.5 Mm (0.079 0.020 In.)

2.  coat the lip of the oil seal with mp grease.

10. Install transaxle case oil seal(lh)

1. Using sst and a hammer, drive in a new oil seal.

   Sst 09350–32014 (09351–32111, 09351–32130) oil seal drive in depth: 5.3 0.5 Mm (0.209 0.020 In.)

2.  coat the lip of the oil seal with mp grease.

11. Install front drive shaft assy lh

12. Install front drive shaft assy rh

13. Install engine under cover lh

14. Install engine under cover rh

15. Install front wheels

torque: 103 nvm (1050 Kgf·cm, 76 ft·lbf)

16. Add automatic transaxle fluid

17. Inspect automatic transaxle fluid

18. Inspect and adjust front wheel alignment

19. Check abs speed sensor signal (w/ abs)