Toyota Corolla (E120): Cooler compressor assy

Share this page:

Other materials:

Pre–check
1. Diagnosis system Release the parking brake lever.  check the warning lights. When the ignition switch is turned on, check that the abs warning light and brake warning light goes on for 3 sec. Hint: when the parking brake is applied or the level of the brake fluid is low, the ...

Oxygen / af sensor heater monitor
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...

Combination meter assy
Overhaul Hint: components: 1. Remove meter hood sub–assy 2. Remove combination meter assy Remove the screw.  disengage the 2 clips as shown in the illustration.  disconnect the connector, then remove the combination meter. 3. Remove combination meter glass Di ...