Toyota Corolla (E120): Combination meter assy

Overhaul

Hint

: components:

1. Remove meter hood sub–assy

2. Remove combination meter assy

  1. Remove the screw.
  2.  disengage the 2 clips as shown in the illustration.
  3.  disconnect the connector, then remove the combination meter.

3. Remove combination meter glass

  1. Disengage the 8 claws, then remove the combination meter glass.
    Share this page:

    Other materials:

    Overhaul
    1. Remove w/head taper screw plug no.2 Using a socket hexagon wench 10, remove the taper screw plug and gasket. 2. Remove valve lifter Remove the valve lifters from the cylinder head. 3. Remove valve Place the cylinder head on wooden blocks.  using sst, compres ...

    Check open circuit
    For the open circuit in the wire harness in fig. 1, Perform a resistance check in step (b) or a voltage check in step (c) to locate the section. Check the resistance.  Disconnect connectors a and c and measure the resistance between them. Resistance: 1 Ω or les ...

    Circuit description
    The intake air temperature (iat) sensor, mounted on the mass air flow (maf) sensor, monitors the intake air temperature. The iat sensor has a thermistor that varies its resistance depending on the temperature of the intake air. When the air temperature is low, the resistance in the thermisto ...