Toyota Corolla (E120) 2002–2008 Repair Manual / Heater & air conditioner / W/receiver condenser assy / On–vehicle inspection
Toyota Corolla (E120): On–vehicle inspection
1. Inspect w/receiver condenser assy
- if a fin of the w/receiver condenser assy is dirty, clean it with water and dry it with compressor air.
Notice
: do not damage the fin of the w/receiver condenser assy.
- if a fin of the w/receiver condenser assy is bent, make it straight using a screwdriver or pliers.
2. Inspect w/receiver condenser assy for leakage of refrigerant
- using a halogen leak detector, check pipe joints for gas leakage.
- if gas leakage is detected in a joint, check the torque of the joint.
Other materials:
Monitor description
While the engine is being cranked, the battery positive voltage is applied to
terminal sta of the ecm.
If the ecm detects the starter control signal (sta) while the vehicle is
driving, it will conclude that there is
a fault in the starter control circuit. The ecm will turn on the mil and a d ...
Emergency towing
If a tow truck is not available in an emergency, your vehicle may be temporarily
towed using a cable or chain secured to the emergency towing eyelet. This should
only be attempted on hard surfaced roads for short distances at low speeds.
A driver must be in the vehicle to steer and operate the ...
Replacement
Hint: components:
1. Precaution
2. Disconnect battery negative terminal
3. Remove horn button assy
Place the front wheels facing straight ahead.
using a torx socket wrench (t30), loosen the 2 torx
screws until the groove along the screw circumference
catches on the screw ca ...


