Toyota Corolla (E120): W/receiver condenser assy

Share this page:

Other materials:

Removal & installation and disassembly & reassembly
1. Remove oxygen sensor Remove a clip and tear off the floor mat.  disconnect a oxygen sensor connector. Remove the oxygen sensor. 2. Remove tail pipe assy Remove 2 bolts, 2 springs and tail pipe assy. 3. Remove floor panel brace front Remove 2 nuts and the ...

Circuit description
The crankshaft position sensor (ne signal) consists of a magnet, iron core and pickup coil. The ne signal plate (crankshaft position sensor plate) has 34 teeth and is installed on the crankshaft. The ne signal sensor generates 34 signals for each engine revolution. This sensor monitors a p ...

Hood
Release the lock from the inside of the vehicle to open the hood. 1 Pull the hood lock release lever. The hood will pop up slightly. 2 Pull up the auxiliary catch lever and lift the hood. 3 Hold the hood open by inserting the support rod into the slot. CAUTION ■Pre-driving check C ...