Toyota Corolla (E120): Seat belt

Share this page:

Other materials:

Check open circuit
For the open circuit in the wire harness in fig. 1, Perform a resistance check in step (b) or a voltage check in step (c) to locate the section. Check the resistance.  Disconnect connectors a and c and measure the resistance between them. Resistance: 1 Ω or les ...

Side mudguard sub–assy lh
Replacement Hint: use the same procedures for the rh side and lh side. 1. Remove side mudguard sub–assy lh Using a clip remover, remove the 8 retainers and 9 clips.  using a moulding remover, remove the mudguard. 2. Install side mudguard sub–assy lh Install the mudgu ...

Terminals of ecu
Oscilloscope wave (*1) Hint: terminal: od – gnd gauge set: 5 v / div, 50 ms / div condition: during cruise control driving o/d switch on. ...