Toyota Corolla (E120): Short in d squib (2nd step) circuit (to ground)

Dtc b1182/19 short in d squib (2nd step) circuit (to ground)

Share this page:

Other materials:

Overhaul
1. Remove bench type rear seat cushion assy Disengage the 2 clamps, and then remove the seat cushion. 2. Remove bench type rear seat back assy  remove the headrests.  remove the 2 bolts and seat back. 3. Remove bench type rear seat cushion cover  remove the ho ...

Inspection procedure
1 Inspect stop lamp switch assy 2 Check harness and connector(stop lamp switch assy – ecm)   Install the stop lamp switch assy.  disconnect the ecm connector.  measure the voltage according to the value(s) in the table below when the brake pedal is depressed and rele ...

Front axle lh hub bolt
Replacement Hint: components: 1. Remove front wheel 2. Separate front disc brake caliper assy lh 3. Remove front disc 4. Remove front axle lh hub bolt Using sst and a hammer handle or an equivalent, remove the lh hub bolt. Sst 09628–10011 5. Install front axle lh hub bolt ...