Toyota Corolla (E120): Circuit description

The d squib (2nd step) circuit consists of the airbag sensor assy center, spiral cable sub–assy and horn button assy.

It causes the srs to deploy when the srs deployment conditions are satisfied.

Dtc b1182/19 is recorded when a ground short is detected in the d squib (2nd step) circuit.

Wiring diagram

Wiring diagram

    Share this page:

    Other materials:

    Checking and replacing fuses
    If any of the electrical components do not operate, a fuse may have blown. If this happens, check and replace the fuses as necessary. 1 Turn the engine switch off. 2 Open the fuse box cover. ► Engine compartment Push the tab in and lift the lid off. ► Under the driver’s side i ...

    When stopping the engine with the shift lever in a position other than P (vehicles with a continuously variable transmission)
    If the engine is stopped with the shift lever in a position other than P, the engine switch will not be turned off but instead be turned to ACCESSORY mode. Perform the following procedure to turn the switch off: 1 Check that the parking brake is set. 2 Shift the shift lever to P. ► Vehi ...

    On–vehicle inspection
    1. Check fuel pump operation Connect the hand–held tester to the dlc3.  turn the ignition switch on and hand–held tester main switch on. Notice: do not start the engine.  select the active test mode on the hand–held tester.  please refer to the hand–held te ...