Toyota Corolla (E120): Open in d squib circuit

Dtc b0101/14 open in d squib circuit

Share this page:

Other materials:

On–vehicle inspection
1. Inspect air–fuel ratio compensation system Hint: you can also check the system by choosing ”data monitor”, then ”o2 sensor output voltage” on the monitor of the hand–held tester. Connect the hand–held tester to the terminal 23 (ox1a) @ 7 (e1) and 21 (ox1b) @ 7 (e1) of ...

Speed sensor front lh
Replacement Hint: replace the rh side by the same procedure as the lh side. 1. Remove front wheel 2. Remove front fender liner lh 3. Remove speed sensor front lh Disconnect the speed sensor wire harness clamp from the body.  disconnect the speed sensor connector. Remo ...

Replacement
1. Remove console box sub–assy rear 2. Remove parking brake lever sub–assy 3. Remove exhaust pipe assy front 4. Remove front floor heat insulator no.1 Remove the 3 nuts and front floor insulator no.1. 5. Remove front floor heat insulator no.2 Remove the 2 nuts and front ...