Toyota Tacoma manuals

Toyota Corolla Repair Manual: Circuit description

The d squib circuit consists of the airbag sensor assy center, spiral cable sub–assy and horn button assy.

It causes the srs to deploy when the srs deployment conditions are satisfied.

Dtc b0101/14 is recorded when an open is detected in the d squib circuit.

Wiring diagram

Wiring diagram

Open in d squib circuit
Dtc b0101/14 open in d squib circuit ...

Inspection procedure
1 Check d squib circuit(airbag sensor assy center – horn button assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the c ...

Other materials:

Sound quality is bad only when cd is played(volume is too low)
Inspection procedure 1 Replace cd with another and recheck Replace the cd with another and recheck.  Check the installation condition of the radio receiver assembly. Standard: malfunction disappear. Check and replace radio receiver assy ...

On–vehicle inspection
1. Connect hand–held tester:  connect the hand–held tester to the dlc3.  start the engine and run it at idle.  select the active test mode on the hand–held tester. Hint: please refer to the hand–held tester operator’s manual for further details. 2. Inspect actuator motor ...

Chassis
On–vehicle inspection 1. Inspect steering linkage  check the steering wheel freeplay .  check the steering linkage for looseness or damage.  Check that the tie rod ends do not have excessive play.  Check that the dust seals and boots are not damaged.  Check ...

© 2011-2022 Copyright www.tcorolla.net