Toyota Corolla (E120) 2002–2008 Repair Manual / Steering column / Steering system / On–vehicle inspection
Toyota Corolla (E120): On–vehicle inspection
1. Check steering wheel freeplay
- Stop the vehicle and face the tires straight ahead.
- rock the steering wheel gently up and down by your
hand, check the steering wheel freeplay.
Maximum freeplay: 30 mm (1.18 In.)
Other materials:
Starting system
Inspection
1. Inspect starter assy
Notice:
these tests must be performed within 3 to 5 seconds to
prevent burnout of the coil.
perform the pull–in test.
Remove the nut, then disconnect the lead wire from
terminal c.
Connect the battery to the starter repai ...
Inspection procedure
1 Inspect skid control ecu connector(+bs terminal voltage)
Disconnect the skid control ecu connector.
measure the voltage between terminals +bs (2) and gnd
(1, 23) of skid control ecu harness side connector.
Voltage: 10 – 14 v
2 Reconfirm dtc
Check the dtc .
Ok :
...
Inspection procedure
1 Inspect shift solenoid valve(s1)
Remove the shift solenoid valve s1.
measure the resistance according to the value(s) in the
table below.
Standard:
Connect the positive (+) battery lead to the solenoid connector
terminal, and the negative (–) battery lead to the
solenoid ...