Toyota Corolla (E120): Steering column

Share this page:

Other materials:

Inspection procedure
Hint: hand–held tester only: narrowing down the trouble area is possible by performing ”a/f control” active test (heated oxygen sensor or other trouble areas can be distinguished).  perform active test using hand–held tester (a/f control). Hint: ”a/f control” is the act ...

On–vehicle inspection
1. Inspect turn signal flasher relay circuit Disconnect the connector from the turn signal flasher relay and inspect the connector on wire harness side as shown in the chart. Standard: Connect the connector to the turn signal flasher and inspect the wire harness side connector ...

Inspection procedure
1 Inspect skid control ecu connector(+bs terminal voltage) Disconnect the skid control ecu connector.  measure the voltage between terminals +bs (2) and gnd (1, 23) of skid control ecu harness side connector. Voltage: 10 – 14 v 2 Reconfirm dtc Check the dtc . Ok : ...