Toyota Corolla (E120): Steering system

Share this page:

Other materials:

Malfunction in speedometer
Wiring diagram Inspection procedure 1 Check combination meter assy Remove the combination meter assy with connector still connected.  check voltage.  Jack up either of the front wheels.  Shift the shift lever to neutral.  Turn the ignition switch to on ...

On–vehicle inspection
1. Inspect w/receiver condenser assy  if a fin of the w/receiver condenser assy is dirty, clean it with water and dry it with compressor air. Notice: do not damage the fin of the w/receiver condenser assy.  if a fin of the w/receiver condenser assy is bent, make it straig ...

Rear axle beam assy
Replacement Hint: components:  1. Remove rear wheel  remove the rh and lh rear wheels. 2. Remove rear brake drum sub–assy 3. Separate skid control sensor wire Disconnect the skid control sensor connector.  remove the 2 bolts and separate the wire harness clamp ...