Toyota Corolla (E210) 2019-2026 Owners Manual / When trouble arises
Toyota Corolla (E210): When trouble arises
- Essential information
- Emergency flashers
- If your vehicle has to be stopped in an emergency
- If the vehicle is submerged or water on the road is rising
- Steps to take in an emergency
- If your vehicle needs to be towed
- If you think something is wrong
- If a warning light turns on or a warning buzzer sounds
- If a warning message is displayed
- If you have a flat tire
- If the engine will not start
- If the electronic key does not operate properly (vehicles with a smart key system)
- If the vehicle battery is discharged
- If your vehicle overheats
- If the vehicle becomes stuck
Other materials:
Light control switch circuit
Wiring diagram
Inspection procedure
1 Check headlamp dimmer switch assy (light control switch)
2 Check wire harness (tvip ecu light control switch)
Disconnect the tvip ecu and light control switch connectors.
check the continuity between the terminals of the tvip
e ...
On–vehicle inspection
1. Check fuel pump operation
Connect the hand–held tester to the dlc3.
turn the ignition switch on and hand–held tester main
switch on.
Notice:
do not start the engine.
select the active test mode on the hand–held tester.
please refer to the hand–held te ...
Emergency flashers
The emergency flashers are
used to warn other drivers
when the vehicle has to be
stopped on the road due to
a breakdown, etc.
Operating instructions
Press the switch.
All the turn signal lights will flash.
To turn them off, press the switch
once again.
■Emergency flashers
If the emergency fla ...


