Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Toyota vehicle intrusion protection system
Toyota Corolla (E120): Toyota vehicle intrusion protection system
- How to proceed with troubleshooting
- Terminals of ecu
- Problem symptoms table
- Indicator light circuit
- Ecu power source circuit
- Ignition switch circuit
- Horn relay circuit
- Light control switch circuit
- Hazard warning switch circuit
- Starter cut relay circuit
- Key unlock warning switch circuit
- Glass breakage sensor circuit
- Door courtesy switch circuit
- Door unlock detection switch circuit
- Door key lock and unlock switch circuit
- Tvip ecu communication circuit
Other materials:
On–vehicle inspection
1. Install lspv gauge (sst) and bleed air
remove the bleeder plugs from the front and rear brake cylinder.
install the lspv gauge (sst), and bleed the air.
Sst 09709–29018
2. Raise master cylinder pressure and check rear wheel cylinder pressure
Hint:
when inspectin ...
Inspection procedure
Hint:
start the inspection from step 1 in case of using the hand–held tester and start
from step 2 in case of not
using hand–held tester.
1 Inspect brake actuator assy
Select the datalist mode on the hand–held tester.
check the operation sound of the abs pump motor when operat ...
Inspection procedure
1 Check side air bag sensor assy lh
Sst 09843–18040
Connect the negative (–) terminal cable to the battery,
and wait at least for 2 seconds.
turn the ignition switch to on, and wait at least for 20 seconds.
clear the dtc stored in memory .
turn the ignition swi ...