Toyota Corolla (E120): On–vehicle inspection

1. Inspection throttle body idle speed control valve assy

Notice:

Notice

:

  • it is impossible to check the resister value and the operation of isc valve by itself, because the isc valve has an ic circuit inside it, which transforms the duty signal from the ecm to the derive signal.
  • After checking, erase the dtc.
  • Clear the dtc after inspection.

Hint

: when the isc valve system has malfunctions except for its adherence, dtc p0505 is detected.

  1. Operation inspection.
  1.  Connect the isc connector to the isc valve.
  2.  Check the isc valve movement when the ignition switch is turned on.

    Movement: half open " fully close " fully open " half open

Hint: isc valve moves within 0.5 Second.

    Share this page:

    Other materials:

    Replacement
    1. Drain brake fluid Notice: wash the brake fluid off immediately if it comes into contact with any painted surface. 2. Remove front wheel rh 3. Remove front fender liner rh 4. Remove brake actuator with bracket  turn the latch of the actuator connector to disconnect the connector. ...

    Tire information
    Typical tire symbols ► Full-size tire ► Compact spare tire 1 Tire size 2 DOT and Tire Identification Number (TIN) 3 Uniform tire quality grading For details, see “Uniform Tire Quality Grading” that follows. 4 Location of treadwear indicators 5 Tire ply composition and ma ...

    Disposal
    1. Dispose shock absorber assy front lh  fully extend the shock absorber piston rod.  using a drill, make a hole in the cylinder as shown in the illustration to discharge the gas inside. Caution: when drilling, chips may fly out, work carefully. The gas is colorless, o ...