Toyota Corolla (E120): Starter cut relay circuit

Share this page:

Other materials:

Inspection procedure
1 Inspect shift solenoid valve(s2) Remove the shift solenoid valve s2.  measure the resistance according to the value(s) in the table below. Standard: Connect the positive (+) battery lead to the solenoid connector terminal, and the negative (–) battery lead to the so ...

Manual air conditioning system∗
Air conditioning controls ► Heater ► Air conditioning system ■ Adjusting the temperature setting ► Heater To adjust the temperature setting, turn the dial clockwise to increase the temperature. ► Air conditioning system To adjust the temperature setting, tu ...

Inspection procedure
1 Inspect dlc3 terminal voltage(ts terminal) Turn the ignition switch to on. measure voltage between terminals ts and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector between ...