Toyota Corolla (E120): Inspection procedure

1 Check hazard warning signal switch assy

  1. Check the hazard warning switch continuity, as shown in the illustration and table.

Standard:

2 Check turn signal flasher assy

2 Check turn signal flasher assy

3 Check wire harness (tvip ecu turn signal flasher)

3 Check wire harness (tvip ecu turn signal flasher)

  1. Disconnect the tvip ecu and turn signal flasher connectors.
  2. check the continuity between the terminals of the tvip ecu and turn signal flasher connectors, as shown in the illustration and table.

Standard:

4 Check wire harness (hazard warning switch  body ground)

4 Check wire harness (hazard warning switch  body ground)

  1. Disconnect the hazard warning switch connector.
  2.  check the continuity between the terminal of the hazard warning switch connector and the body ground, as shown in the illustration and table.

Standard:

Check and replace tvip ecu

Check and replace tvip ecu

    Share this page:

    Other materials:

    Hydraulic test
    1. Perform hydraulic test Measure the line pressure. Notice: Do the test at normal operation atf temperature 50 to 80 °c (122 to 176 °f). The line pressure test should always be carried out in pairs. One technician should observe the conditions of wheels or wheel stopper outsi ...

    Engine immobilizer system
    The vehicle's keys have built-in transponder chips that prevent the engine from starting if a key has not been previously registered in the vehicle's on-board computer. Never leave the keys inside the vehicle when you leave the vehicle. This system is designed to help prevent vehicle theft but doe ...

    Circuit description
    The p squib circuit consists of the airbag sensor assy center and instrument panel passenger airbag assy. It causes the srs to deploy when the srs deployment conditions are satisfied. Dtc b0105/53 is recorded when a short is detected in the p squib circuit. Wiring diagram ...