Toyota Corolla (E120): Circuit description

When the tvip system is transferred to the alarm sounding state from the armed state, the signal flasher assembly (relay for hazard warning lights) will be switched on and the hazard warning lights will start blinking.

Wiring diagram

Inspection procedure

    Share this page:

    Other materials:

    Body panel undercoating areas
    Apply pastar uwe or pastar uc to the chassis, floor underside, sheet metal fitting weld points of the body, and inside of the wheel house to prevent rust and noise, as well as protect the body from flying rocks. Hint:  work must be performed while wearing the appropriate protective ...

    Overhaul
    Hint: overhaul the rh side by the same procedures with lh side. 1. Remove rear wheel 2. Drain brake fluid Notice: wash the brake fluid off immediately if it comes into contact with any painted surface. 3. Remove rear brake drum sub–assy Release the parking brake lever, and remove t ...

    Calibrating the compass
    The direction display deviates from the true direction determined by the earth’s magnetic field. The amount of deviation varies according to the geographic position of the vehicle. If you cross over a map boundary shown in illustration, the compass will deviate. To obtain higher precision or ...