Toyota Corolla (E140): Foamed material application areas

If an increase in temperature or other condition damages the foamed material when repairing or replacing the panel, fill in the insufficient areas with urethane foam. The following illustration shows the areas for one side, but the foamed material must be applied equally to both the left and right sides.

Hint:

  1.  work must be performed while wearing the appropriate protective gear and in a will-ventilated area.
  2.  Apply tape or equivalent to any holes, nuts, etc., Near the areas to be filled.

Body panel anti-rust agent (wax) application areas

    Share this page:

    Other materials:

    Continuously variable transmission (vehicles with paddle shift switches)
    Select the shift position depending on your purpose and situation. Shift position purpose and functions P - Parking the vehicle/ starting the engine R - Reversing N - Neutral (Condition in which the power is not transmitted) D - Normal driving* M - 10-speed sport sequential shiftmatic mode driving * ...

    Inspection procedure
    1 Check p squib circuit(airbag sensor assy center – instrument panel passenger airbag assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the instrument panel ...

    Inspection
    1. Cooling fan relay Inspect the cooling fan relay continuity.  Using an ohmmeter, check that there is continuity between terminals 1 and 2. If there is no continuity, replace the relay.  Check that there is no continuity between terminals 3 and 5. If there is conti ...