Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Toyota vehicle intrusion protection system / Starter cut relay circuit / Inspection procedure
Toyota Corolla (E120): Inspection procedure
1 Check relay (marking: starter cut)

- Inspect the relay continuity, as shown in the illustration and table.
Standard:



2 Check tvip ecu

- Disconnect the tvip ecu connector.
- turn the ignition switch position to the start.
- measure the voltage between the terminal of the ecu connector and the body ground, as shown in the illustration and table.
Standard:



Check and replace tvip ecu
Other materials:
Evap monitor (vacuum pressure monitor)
Notice:
a cold soak must be performed prior to conducting the drive pattern to complete
the internal pressure
readiness monitor.
Cold soak preconditions
The monitor will not run unless:
mil is off.
Fuel level is approximately 1/2 to 3/4.
Altitude is 7800 feet (2400 m) or less.
...
Seat belts
Make sure that all occupants
are wearing their seat
belts before driving the
vehicle.
WARNING
Observe the following precautions
to reduce the risk of injury in the
event of sudden braking, sudden
swerving or an accident.
Failure to do so may cause death
or serious injury.
■Wearing a seat belt
E ...
Malfunction in tachometer
Wiring diagram
Inspection procedure
Check output value of ecm.
Connect the hand–held tester to dlc3.
Turn the ignition switch to on and push the hand–held tester main switch
on.
Select the data list mode on the hand–held tester.
2 Inspect combinatio ...


