Toyota Corolla (E120): Tvip ecu communication circuit

Share this page:

Other materials:

On–vehicle inspection
1. Inspect drive belt Visually check the belt for excessive wear, frayed cords, etc. If any defect is found, replace the drive belt. Hint: cracks on the rib side of a belt are considered acceptable. If the missing chunks from the ribs are found on the belt, it should be replaced. 2 ...

Connecting a Bluetooth® device
Up to 5 Bluetooth® devices (Phones (HFP) and audio players (AVP)) can be registered. If more than 1 Bluetooth® device has been registered, select which device to connect to. 1 Press the “SETUP” button. 2 Select “Bluetooth*”. *: Bluetooth is a registered trademark of Bluetooth SIG, In ...

Deactivating or stopping the alarm
Do one of the following to deactivate or stop the alarm: ● Unlock the doors or open the trunk. ● Vehicles without a smart key system: Turn the engine switch to the “ACC” or “ON” position, or start the engine. (The alarm will be deactivated or stopped after a few seconds.) & ...