Toyota Corolla (E120): Refrigerant

Share this page:

Other materials:

Removal & installation and disassembly & reassembly
1. Remove bench type rear seat cushion assy 2. Remove rear floor service hole cover Remove the rear service hole cover. Disconnect the fuel pump and vapor pressure sensor connector. 3. Work for preventing gasoline from spilling out Start the engine.  after the engi ...

Inspection
1. Cooling fan relay Inspect the cooling fan relay continuity.  Using an ohmmeter, check that there is continuity between terminals 1 and 2. If there is no continuity, replace the relay.  Check that there is no continuity between terminals 3 and 5. If there is conti ...

Evap monitor (vacuum pressure monitor)
Notice: a cold soak must be performed prior to conducting the drive pattern to complete the internal pressure readiness monitor. Cold soak preconditions The monitor will not run unless: mil is off. Fuel level is approximately 1/2 to 3/4. Altitude is 7800 feet (2400 m) or less. ...