Toyota Corolla (E210): Adjusting the seats

Share this page:

Other materials:

Inspection procedure
1 Inspect stop lamp switch assy 2 Check harness and connector(stop lamp switch assy – ecm)   Install the stop lamp switch assy.  disconnect the ecm connector.  measure the voltage according to the value(s) in the table below when the brake pedal is depressed and rele ...

Terminals of ecu
Oscilloscope wave (*1) Hint: terminal: od – gnd gauge set: 5 v / div, 50 ms / div condition: during cruise control driving o/d switch on. ...

How to proceed with troubleshooting
1 Vehicle brought to workshop 2 Customer problem analysis 3 Check and clear dtc 4 Problem symptom confirmation 5 Symptom simulation 6 Dtc check 7 Dtc chart 8 Problem symptoms table 9 Circuit inspection 10 Identification of problem 11 Parts inspection 12 Repair 1 ...