Toyota Corolla (E210): Specifications

Share this page:

Other materials:

Overhaul
1. Remove w/head taper screw plug no.2 Using a socket hexagon wench 10, remove the taper screw plug and gasket. 2. Remove valve lifter Remove the valve lifters from the cylinder head. 3. Remove valve Place the cylinder head on wooden blocks.  using sst, compres ...

Inspection procedure
1 Inspect dlc3 terminal voltage(ts terminal) Turn the ignition switch to on. measure voltage between terminals ts and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector between ...

How to proceed with troubleshooting
1 Vehicle brought to workshop 2 Customer problem analysis 3 Check and clear dtc 4 Problem symptom confirmation Symptom does not occur (go to step 5) 5 Symptom simulation 6 Dtc check 7 Dtc chart 8 Problem symptoms table 9 Circuit inspection 10 Confirmation test End ...