Toyota Corolla (E120): Brake pedal sub–assy

Share this page:

Other materials:

Rear axle beam assy
Replacement Hint: components:  1. Remove rear wheel  remove the rh and lh rear wheels. 2. Remove rear brake drum sub–assy 3. Separate skid control sensor wire Disconnect the skid control sensor connector.  remove the 2 bolts and separate the wire harness clamp ...

Dtc check/clear
Notice: if there is no dtc in the normal mode, check the pending fault code using the continuous test results function (mode 7 for sae j1979) on the obd ii scan tool or the hand–held tester. Hand–held tester only: when the diagnosis system is switched from the normal mode to the ...

How to proceed with troubleshooting
1 Vehicle brought in 2 Customer problem analysis check and symptom check 3 Problem symptoms table Without applicable symptoms, proceed to ”a”  with applicable symptoms, proceed to ”b” 4 Perform troubleshooting in the following method, depending on malfunction symptom ...