Toyota Corolla (E170): Bluetooth® phone settings

You can adjust the hands-free system to your desired settings.

Share this page:

Other materials:

On–vehicle inspection
1. Inspect turn signal flasher relay circuit Disconnect the connector from the turn signal flasher relay and inspect the connector on wire harness side as shown in the chart. Standard: Connect the connector to the turn signal flasher and inspect the wire harness side connector ...

Evap monitor (vacuum pressure monitor) (continued)
Preconditions The monitor will not run unless: mil is off. Fuel level is approximately 1/2 to 3/4. Altitude is 7800 feet (2400 m) or less.* Engine coolant temperature (ect) is between 40°f and 95°f (4.4 °C and 35 °C). Intake air temperature (iat) is between 40°f and 95 ...

Inspection procedure
1 Check d squib circuit(airbag sensor assy center – horn button assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the horn button assy.  connect the ...