Toyota Corolla (E120): Adjustment

1. Inspect park/neutral position switch assy

  1.  apply the parking brake and turn the ignition switch on.
  2.  depress the brake pedal and check that the engine starts only when the shift lever is set in n or p position and it does not start in the other position.
  3.  check that the back–up light comes on and the reverse warning buzzer sounds only when the shift lever is set in r position and these do not function in the other positions.

    If a failure is found, check the park/ neutral position switch for continuity.

2. Adjust park/neutral position switch assy

  1. Loosen the 2 bolts of park/ neutral position switch and set the shift lever to the n position.
  2.  align the groove and neutral basic line.
  3.  hold the switch in position and tighten the 2 bolts.

    Torque: 5.5 Nvm (56 Kgf·cm, 49 in.Vlbf)

  4.  after adjustment, perform the inspection described in step 1.
    Share this page:

    Other materials:

    Overhaul
    1. Remove cylinder block water drain cock sub–assy Remove the cylinder block water drain cock from the cylinder block. 2. Inspect connecting rod thrust clearance Using a dial indicator, measure the thrust clearance while moving the connecting rod back and forth. Standard t ...

    Deactivating or stopping the alarm
    Do one of the following to deactivate or stop the alarm: ● Unlock the doors or open the trunk. ● Vehicles without a smart key system: Turn the engine switch to the “ACC” or “ON” position, or start the engine. (The alarm will be deactivated or stopped after a few seconds.) & ...

    Dialing from call history
    You can make a call using the call history, which has the 3 functions below. : calls which you missed : calls which you received : calls which you made 1 Display the phone screen. 2 Select “Call History” tab. 3 Select or the desired entry from the list. ► When is selected 4 C ...