Toyota Corolla (E170): Speaking on the phone

The following screen is displayed when speaking on the phone.

To adjust the call volume

To adjust the call volume

Select “-” or “+”. You can also adjust the volume using the steering switches or the volume knob.

To prevent the other party from hearing your voice

Select “Mute”.

Inputting tones

When using phone services such as an answering service or a bank, you can store phone numbers and code numbers in the contact.

1 Select “0-9”.

2 Input the number.

■ Release Tones

“Release Tones” appear when a continuous tone signal(s) containing a (w) is registered in the contact list.

1Select “Release Tones”.

■Release Tones

●A continuous tone signal is a character string that consists of numbers and the characters p or w. (e.g.056133w0123p#1*) ●When the “p” pause tone is used, the tone data up until the next pause tone will be automatically sent after 2 seconds have elapsed. When the “w” pause tone is used, the tone data up until the next pause tone will be automatically sent after a user operation is performed.

●Release tones can be used when automated operation of a phone based service such as an answering machine or bank phone service is desired. A phone number with continuous tone signals can be registered in the contact list.

●Tone data after a “w” pause tone can be operated on voice command during a call.

To transfer a call

Select “Handset Mode” to on from a hands-free call to a cellular phone call.

Select “Handset Mode” to off from a cellular phone call to a hands-free call.

Transmit volume setting

1 Select “Transmit Volume”.

2 Select the desired level for the transmit volume.

3 Select “OK”.

To hang up

Press the wheel or select .  switch on the steering wheel or select Call waiting.

Call waiting

When a call is interrupted by a third party while talking, an incoming call message will be displayed.

To talk with the other party: • Press the • Select . switch on the steering wheel.

• Select To refuse the call:.

To refuse the call:

• Press the wheel. switch on the steering wheel.

• Select Every time you press the  switch.

Every time you press the on the steering wheel or select  during switch on the steering wheel or select call waiting, you will be switched to the other party. during call waiting, you will be switched to the other party.

■Transferring calls

■Transferring calls

●If you transfer from the cellular phone to hands-free, the hands-free screen will be displayed, and you can operate the system using the screen.

●Transfer method and operation may vary according to the cellular phone used.

●For operation of the cellular phone in use, see the phone's manual.

■Call waiting operation

Call waiting operation may differ depending on your phone company and cellular phone.

    Share this page:

    Other materials:

    Replacement
    1. Remove instrument panel sub–assy lower 2. Remove clutch pedal spring 3. Remove clutch master cylinder push rod clevis w/hole pin Remove the clip and hole pin. 4. Remove clutch pedal support sub–assy W/ cruise control: disconnect the clutch switch assy connector. &nbs ...

    Basic inspection
    When the malfunction is not confirmed in the dtc check, troubleshooting should be carried out in all the possible circuits considered as causes of the problem. In many cases, by carrying out the basic engine check shown in the following flowchart, the location causing the problem can be found ...

    Adjustment
    Hint: in the rh side, work in the same procedure as in the lh side. Since the centering bolt is used as a door side hinge bolt, the door hinge cannot be adjusted with it on. Substitute the bolt with washer for the centering bolt. 1. Inspect rear door panel sub–assy lh Check ...