Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Sfi system / Throttle/pedal position sensor/switch ”a” circuit

Toyota Corolla (E120): Throttle/pedal position sensor/switch ”a” circuit

Dtc p0120 throttle/pedal position sensor/switch ”a” circuit

Dtc p0122 throttle/pedal position sensor/switch ”a” circuit low input

Dtc p0123 throttle/pedal position sensor/switch ”a” circuit high input

Hint

: this is the purpose for the ”throttle position sensor”.

Share this page:

Other materials:

Oxygen sensor monitor (front and rear o2s system)
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 2 minutes or more.  Drive the vehicle at 25 mph ...

Inspection procedure
1 Check side squib(rh) circuit(airbag sensor assy center – front seat airbag assy rh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the front seat airbag assy ...

Overhaul
1. Remove console panel upper 2. Remove console box carpet 3. Remove parking brake hole cover sub–assy 4. Remove console box sub–assy rear 5. Disconnect floor shift cable transmission control shift Remove the cable end from the rod of the floor shift assembly. Using a s ...