Malfunction in tachometer
Wiring diagram
Inspection procedure
Check output value of ecm.
Connect the hand–held tester to dlc3.
Turn the ignition switch to on and push the hand–held tester main switch
on.
Select the data list mode on the hand–held tester.
2 Inspect combination mete ...
Circuit description
When the ignition switch is turned on, battery positive voltage is applied to
the coilwhich closes the contacts
of the efi main relay (marked: efi) and supplies power to terminal +b of the ecm.
This signal causes current to flow to the coil, closing the contacts of the efi
relay and supplyin ...
Rear axle beam assy
Replacement
Hint: components:
1. Remove rear wheel
remove the rh and lh rear wheels.
2. Remove rear brake drum sub–assy
3. Separate skid control sensor wire
Disconnect the skid control sensor connector.
remove the 2 bolts and separate the wire harness
clamps. ...