Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Cruise control system / Stop light switch circuit
Toyota Corolla (E120): Stop light switch circuit
Other materials:
Inspection procedure
1 Prepare for inspection
Disconnect the negative (–) terminal cable from the battery, and wait at
least for 90 seconds.
remove the horn button assy .
disconnect the connector of the instrument panel passenger airbag assy
.
disconnect the connector of the front sea ...
Circuit description
Refer to dtc p0130
Dtc no.
Dtc detection condition
Trouble area
P0133
After engine has been warmed up, if response time that heated
oxygen sensor’s output voltage reaches from rich to lean.
Or from lean to rich, is 0.6 Second or more during idling.
...
Fail–safe chart
If any of the following codes is recorded, the ecm enters the fail–safe mode.
Check for intermittent problems
Hand–held tester only:
by putting the vehicle’s ecm in the check mode, the 1 trip detection logic is
possible instead of the
2 trip detection logic, and the sensitivity to de ...


