Toyota Corolla (E120): Shift solenoid ”a” control circuit low/high

Dtc p0973 shift solenoid ”a” control circuit low (shift solenoid valve s1)

Dtc p0974 shift solenoid ”a” control circuit high (shift solenoid valve s1)

Share this page:

Other materials:

Rear seats
► Type A 1 Up Pull the head restraints up. 2 Down Push the head restraint down while pressing the lock release button. ► Type B 1 Up Pull the head restraints up. 2 Down Push the head restraint down while pressing the lock release button. ■Removing the head restraints ...

Oxygen sensor monitor (front and rear o2s system)
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 2 minutes or more.  Drive the vehicle at 25 mph ...

Replacement
Hint: components: 1. Remove rear wheel 2. Remove rear brake drum sub–assy 3. Disconnect skid control sensor wire (w/ abs) 4. Remove rear axle hub & bearing assy lh Remove the 4 bolts and hub & bearing assy lh. 5. Install rear axle hub & bearing assy lh Install t ...