Toyota Corolla (E120): Inspection procedure
1 Inspect shift solenoid valve(s2)
- Remove the shift solenoid valve s2.
- measure the resistance according to the value(s) in the table below.
Standard:
- Connect the positive (+) battery lead to the solenoid connector terminal, and the negative (–) battery lead to the solenoid body for checking the solenoid valve operation.
Standard: the solenoid makes an operating noise.
2 Inspect transmission valve body assy(see chapter 2 in the problem symptoms table) (
Repair or replace automatic transaxle assy
Other materials:
Body rocker panel moulding lh
Replacement
Hint:
use the same procedures for the rh side and lh side.
1. Remove body rocker panel moulding lh
Remove the 8 retainers.
using a screwdriver, remove the moulding.
Hint:
tape the screwdriver tip before use.
remove the 7 clips from the moulding.
2. Insta ...
Pre–check
1. Srs warning light check
Turn the ignition switch to the on position and check that
the srs warning light lights up.
check that the srs warning light goes out after approx.
6 Seconds.
Hint:
when the ignition switch is at on and the srs warning
light remains on or flashes, the ...
On–vehicle inspection
1. Check basic function (manual operation function)
turn the ignition switch on.
Check that the door glass moves up when each window switch of the
regulator master switch
assembly is turned up and moves down when each window switch is turned down.
Check that the do ...