Toyota Corolla (E170): Radiator and condenser

Check the radiator and condenser and clear away any foreign objects.

If either of the above parts is extremely dirty or you are not sure of their condition, have your vehicle inspected by your Toyota dealer.

CAUTION

■When the engine is hot

Do not touch the radiator or condenser as they may be hot and cause serious injuries, such as burns.

    Share this page:

    Other materials:

    Overhaul
    1. Remove generator pulley Sst 09820–63010 (09820–06010, 09820–06020) Hint: Hold sst 1 – a with a torque wrench, and tighten sst 1 – b clockwise to the specified torque. Torque: 39 nvm (398 Kgf·cm, 29 ft·lbf) Notice: check that sst is secured to the rotor shaft. ...

    Terminals of ecu
    Oscilloscope wave (*1) Hint: terminal: od – gnd gauge set: 5 v / div, 50 ms / div condition: during cruise control driving o/d switch on. ...

    Inspection procedure
    1 Check harness and connector(transmission control switch – body ground) Disconnect the transmission control switch connector of shift lever assy. measure the resistance according to the value(s) in the table below. Standard: 2 Inspect transmission control switch M ...